{{ 'fb_in_app_browser_popup.desc' | translate }} {{ 'fb_in_app_browser_popup.copy_link' | translate }}
{{ 'in_app_browser_popup.desc' | translate }}
{{ childProduct.title_translations | translateModel }}
{{ getChildVariationShorthand(childProduct.child_variation) }}
{{ getSelectedItemDetail(selectedChildProduct, item).childProductName }} x {{ selectedChildProduct.quantity || 1 }}
{{ getSelectedItemDetail(selectedChildProduct, item).childVariationName }}
SOLD OUT
Not enough stock. Please adjust your quantity.
{{'products.quick_cart.out_of_number_hint'| translate}}
{{'product.preorder_limit.hint'| translate}}
Limit -1 per order.
{{'products.quick_cart.quantity_of_stock_hint'| translate : {message: quantityOfStock} }}
※本賣場大多為Diy電子零件
※使用者需要有基礎的電子概念
該模組立體聲輸出,內置藍牙天線結構簡單,可作為普通供放、有源音箱增加藍牙接功能。7PIN輸出接口為間距2.54通孔。
7PIN輸出接口為:
1. +電源:接電源正極,電壓範圍4.2V-5V,請確保供電在此範圍內,高過這個範圍可能損壞模組,或者導致工作不正常。
2. 地:GND接電源負極
3. 左聲道:接供放板左聲道輸入,或者耳機的左聲道,建議在該輸出端口接入一個電容(是供放所匹配的輸入而定)。
4. 右聲道:接供放板右聲道輸入,或者耳機的右聲道,建議在該輸出端口接入一個電容(是供放所匹配的輸入而定)。
5. MUTE靜音:該端口預設為高電平,當靜音時該端口輸出低電平。
6. LED狀態指示:當藍牙未連接時,該燈快閃,藍牙連接成功後則變慢閃。
7. 預留接口:該端口已經上拉到5V,當該端口給一個低電平觸發後關機,當再次給該端口一個低電則開機。
其中LED狀態端口,外接一下100歐電阻串聯LED指示接到地,藍牙未連接時為快閃,藍牙連接成功為慢閃。
注意:電容不是非接不可,萬一供放板沒有輸入電容才接的,或者有電源干擾才並在電源上面,一般不用的,關於電阻是接在LED上面的。